21
Reinstall the gimbal holder after using the aircraft to protect the gimbal from
unwanted movements when not in use.
Preparing the Remote Controller
¾
To power up the remote controller
Press and hold the
button for 2 seconds until it lights up as solid green.
IMPORTANT
• Remove the aircraft wrapping from the four arms before powering on.
• Power up the remote controller before turning on the aircraft.
¾
To power off the remote controller
Press and hold the
button for 2 seconds until you hear a short beep sound.
NOTE
The remote controller makes an alert sound after 15 minutes of
inactivity, and turns off automatically after 30 minutes of inactivity.
When powering on/off the remote controller, you can check the CE/FCC standard
on the upper left corner as shown below.
2.
Flip over the protector on the Power
Port of the remote controller, and
plug the small circular connector into
the Port.
3.
Plug the charger into a power outlet.
●
The battery level indicator
lights on the aircraft battery will
illuminate and indicate the current
battery level during charging, and
will turn off when the battery is
fully charged.
Battery Level Indicator Status While Charging
●
- Indicates solid green light;
◎
– Indicates flashing green light
●
The
button on the remote controller will illuminate solid green light
(when RC power on) or solid red light (when RC power off) during
charging. When charging is completed, it is prompted on the
Flight
Information Panel
,
and
you will hear two beep sounds.
4.
When charging is completed, disconnect the charger and the aircraft
battery/remote controller.
NOTE
For a full charge, the aircraft battery requires 1 hour and the remote
controller requires 4.5 hours approximately.
Removing the Gimbal Holder
Remove the gimbal holder before powering up the aircraft to avoid damage. Pull
out the attached gimbal holder carefully as illustrated below.
