15
①
GPS Signal
Indicates the signal strength of GNSS
satellites.
②
Video Link Signal
Indicates the WiFi video signal (
X-Star
) or HD
video signal (
X-Star Premium
) strength.
③
Flight Orientation
Indicates the yaw angle relative to the north.
④
Remote Controller Signal
Indicates the control signal strength of the
remote controller.
⑤
Remote Controller Battery
Indicates the battery level of the remote
controller.
⑥
Aircraft Battery
Indicates the battery level of the aircraft.
⑦
Flight Speed
Indicates the flight speed of the aircraft.
⑧
Tilt Angle
Indicates the tilt angle of the camera.
⑨
Flight Distance
Indicates the horizontal distance between the
aircraft and the home point.
⑩
Flight Altitude
Indicates the altitude of the aircraft relative to
the home point.
⑪
Flight Status Bar
Displays the real-time flight status, the function
of the button you have activated, and warning
messages.
Indicator Lights
On the remote controller, there are 5 indicator lights in total. They are found on
the Motor Starter
, the Take-off/Landing Button
, the Power Button
, the
Go Home Button
, and the Pause Button
. Each of them shows a different
status in a different situation.
The remote controller and the aircraft are bound by default when both devices
are powered up. However, when you change an aircraft or remote controller,
or activate the
RC Binding Button
on the aircraft, you need to rebind your
aircraft and remote controller.
¾
To bind the aircraft and remote controller
1.
Turn off the remote controller.
2.
Turn on the aircraft.
3.
Press and hold the
RC Binding
Button
on the aircraft for about 3
seconds, and the binding indicator
beside the
RC Binding Button
will flash slowly in green light
indicating the aircraft is ready to
rebind.
4.
Press and hold the (
) and
( ) buttons on the remote
controller, and the binding indicator
will turn to solid green light once
your binding is successful.
NOTE
You may also use the app to bind the aircraft and remote controller via
Settings ( ) > RC Settings ( ) > RC Binding
. ( 5
2)
z
Main Interface
When the video link has been connected properly, the main interface will
appear as follows:
