AURATON R30 RT, Руководство пользователя

Страница: 8 / 32

8
1
2 3
4
Installation of the AURATON RT receiver
CAUTION! The cables delivered in a set
together with the controller are suitable
for maximum loads equal to 2.5 A.
If devices with higher power are connect-
ed, the cables should be replaced with ones
of appropriate cross-sections.
NOTE: When installing an AURATON RT receiver,
make sure that the power supply is switched off.
The receiver should be installed by a professional.
cable tie
clamp
mounting plug
NOTE: In the permanent system of the building
there must be a switch and an overcurrent pro-
tection.
NOTE: In order to facilitate installation, the ter-
minals are fitted with extendable clamps. Before
cable connections are made, they can be discon-
nected from the controllers. The cables may be
routed from the bottom of the receiver by break-
ing out holes in the mounting cover or from the
back of the receiver if the cables are extended
from the wall. In order to connect the cables
from the back, the cover must be broken out.
1. Take off the cover of the front part of the
AURATON RT receiver by unscrewing the
screws half way out.
2. Connect the heating device to the terminals
of the control connection of the AURATON RT
receiver. Follow the service instruction of the
heating device. The COM (common) and NO
(normally opened) terminals are used the
most often.
3. Connect the power supply cables to the ter-
minals of the power supply connection of the
AURATON RT receiver, in observance of safety
rules.
4. After the cables are connected, they must
be fixed with the “cable fastening holder”
and the covers must be screwed back to the
AURATON RT receiver.
!