AURATON R30 RT, Руководство пользователя

Страница: 12 / 32

12
RESET – Unpairing all devices paired with
the AURATON RT receiver
Signaling of operation and receipt of data packets
In order to unpair all devices paired with the AURATON RT receiver, simultaneously press
and hold both the pairing and the unpairing button ( and ) for at least 5 seconds,
until the LED diode starts blinking green and red alternately. Then release both buttons.
Sound signal: when the button is pressed, a short sound signal is emitted, followed by
another short signal 5 seconds later.
Successful completion of unpairing of all devices is signalized after about 2 seconds by the
diode color changing to green and then switching off for a short time.
Each reception of radio transmission from a paired device is indicated by the AURATON RT
receiver by a momentary change of the color of the LED diodes. After the relay becomes
activated, the LED diode is red and after it is switched off – it is green.
In the event of an unpairing error, steps 1 and 2 must be repeated. If more errors occur, all
devices must be unpaired (see „RESET – Unpairing all devices paired with the AURATON
RT receiver”).
NOTE: If the power supply of the AURATON RT receiver is switched off and then switched
on after the RESET, the receiver automatically goes into the “pairing” mode for 120
seconds. A newly purchased (separately from the controller) AURATON RT receiver acts
in the same way if it has no factory-paired devices.
NOTE: When any button is pressed, a short sound signal is emitted.
2. On the AURATON R30 RT, the
button must be pressed for 5 seconds until the
transmission symbol ( ) is illuminated on the display. Release the button.
3. Successful unpairing is indicated by the LED diode on the AURATON RT receiver no
longer blinking red, emission of a single sound signal, and the receiver switching to
normal operation.