AURATON R30 RT, Руководство пользователя

Страница: 11 / 32

11
Pairing of the wireless AURATON R30 RT
controller with the AURATON RT receiver
Unpairing of the controller and the RT receiver
After the receiver is connected to the network, the receiver must be switched on by
quickly pressing the power button ( ). If the device is switched on, the green power
supply diode becomes illuminated and a single sound signal is emitted. In order to switch
off the receiver, e.g. outside of the heating season, press the power button and hold it
for 3 seconds until a double sound signal is audible and the green power supply diode is
switched off and, consequently, the heating device is switched off.
In the event of a pairing error, steps 1 and 2 must be repeated. If more errors occur, all
devices must be unpaired by RESETTING the AURATON RT receiver (see „RESET - Unpairing
all devices paired with the AURATON RT receiver”) and then an attempt must be made to
pair the devices again.
NOTE: Only 1 temperature controller may be paired with one receiver.
NOTE: If the wireless controller AURATON R30 RT is sold together with the
AURATON RT receiver, the two devices are factory-paired. Devices purchased sepa-
rately must be paired.
1. Pairing of the AURATON R30 RT controller with the AURATON RT receiver is initiated
by pressing the right pairing button ( ) – a single sound signal is emitted - on the
AURATON RT receiver and by holding it pressed for at least 3 s until the LED diode starts
blinking with green light (double sound signal) – then the button must be released.
The AURATON RT receiver waits for pairing for 120 seconds. After this period, it auto-
matically returns to normal operation.
2. On the AURATON R30 RT, the button must be pressed for 5 seconds until the
transmission symbol ( ) is illuminated on the display. Release the button – the
controller emits the pairing signal for 5 seconds.
3. Successful end of pairing is indicated by the LED diode on the AURATON RT receiver
no longer blinking green, emission of a single sound signal, and the receiver switching
to normal operation.
1. Unpairing of the AURATON R30 RT controller from the AURATON RT receiver is in-
itiated by pressing the left unpairing button ( ) on the receiver and holding it for
at least 3 seconds until the LED diode starts blinking red - then the button must be
released. The sound signal works in the same way as during pairing, i.e. when a button
is pressed, a short sound is emitted and another short sound signal after 3 seconds.
The receiver waits for pairing for 120 seconds. After this period, it automatically returns
to normal operation.