Set end position OPEN:
2.
Use crank handle/handwheel or push button [1] for running actuator to end
position OPEN. (Actuator runs at reduced output speed in setting mode.)
Information: One of the reasons that end positions OPEN cannot be set (left
indication light is blinking in red) could be that the stroke between both end
positions (OPEN/CLOSED) is too large. In this instance, the primary reduction
gearing must be replaced (by the AUMA service).
3.
Press push button [2] – hold it down and press push button [1]. Hold both push
buttons down until the left indication light is blinking in green (default).
➥
Once the left indication light is illuminated in green (default), end position OPEN
setting is complete.
4.
Once both end positions are set, perform a reference operation, i.e. both end
positions must be approached again – either via push buttons [1]/[3] (in operation
mode Local) or from Remote (deactivate operation mode Local).
Deactivate operation mode Local:
5.
Hold down push button [2] for approx. 3 seconds until blue indication light goes
out.
➥
Now, the actuator can be controlled from Remote:
-
via operation commands (OPEN - STOP - CLOSE) in positions OPEN or
CLOSED.
-
as an option via setpoint indication (e.g. 0/4 – 20 mA) in defined positions
between 0 % and 100 % of setting range.
Information
●
If the left indication light is blinking in yellow once the setting of both end posi-
tions is performed, the stroke between both end positions (OPEN/CLOSED) is
too small.
10.3.
Switch compartment: open
The switch compartment must be opened to perform the following settings (options).
→
Loosen screws [2] and remove cover [1] from the switch compartment.
Figure 26:
10.4.
Potentiometer setting
The potentiometer is used as travel sensor and records the valve position.
36
SVC 05.1 – SVC 07.5/ SVCR 05.1 – SVCR 07.5
Commissioning (basic settings at actuator)
Содержание SVC 05.1
Страница 50: ...50 SVC 05 1 SVC 07 5 SVCR 05 1 SVCR 07 5...
Страница 51: ...51 SVC 05 1 SVC 07 5 SVCR 05 1 SVCR 07 5...
