AudioCodes MediaPack MP-114, Руководство пользователя

Страница: 89 / 164

User's Manual 6. Configuration Using the Web Interface
Version 6.6 89 MediaPack Series
6.5.2.2.1 Changing VLAN Mode and ‘Native’ VLAN ID
The Interface Table web page allows the user to change the VLAN Mode (enable or
disable VLANs), as well as to change the value of the ‘Native’ VLAN ID.
When configuring more than one network interface, VLANS must be enabled.
In order to change one of these parameters, open the Network Settings->IP Settings page.
The VLAN Mode and ‘Native’ VLAN ID parameters are displayed below the Interface
Table.
Note that any change of these parameter values will only be applied after burning the
configuration and booting from Flash (not using a BOOTP/DHCP server).
Refer to the Interface Table Configuration Summary and Guidelines section in the
MGCP/MEGACO Product Reference Manual, to ensure a successful configuration.
6.5.2.3 Static Route Table
The IP Routing Table page allows you to define up to 30 static IP routing rules for the
device. These rules can be associated with a network interface (defined in the Multiple
Interface table) and therefore, the routing decision is based on the source subnet/VLAN. If
not associated with an IP interface, the static IP rule is based on destination IP address.
Traffic destined to the subnet specified in the routing rule is re-directed to the defined
gateway, reachable through the specified interface. Before sending an IP packet, the
device searches this table for an entry that matches the requested destination
host/network. If such an entry is found, the device sends the packet to the indicated router.
If no explicit entry is found, the packet is sent to the default gateway.

To configure static route:
1. Open the IP Routing Table page ( Configuration tab > VoIP menu > Network >
Static Routing Table ).
2. Click the Add button; the following dialog box appears:
Figure 54: Static Route Table
3. Click Submit to apply your settings.
Notes:
•
You can delete only inactive routing rules.
•
The IP Routing table can also be configured using the table ini file
parameter, StaticRouteTable.