AudioCodes MediaPack MP-114, Руководство пользователя

Страница: 16 / 164

User's Manual 16 Document #: LTRT-71405
MediaPack Series
3.2 Assigning an IP Address Using HTTP

To assign an IP address using HTTP:
1. Connect your PC to the device. Either connect the network interface on your PC to a
port on a network hub / switch (using an RJ-45 Ethernet cable), or use an Ethernet
cross-over cable to directly connect the network interface on your PC to the RJ-45
jack on the device.
2. Change your PC’s IP address and subnet mask to correspond with the device factory
default IP address and subnet mask, shown in the table above. For details on
changing the IP address and subnet mask of your PC, refer to Windows™ Online Help
(Start>Help and Support).
3. Access the Web interface (refer to the Web interface chapter in the Product Reference
Manual).
4. Click Reset and click OK in the prompt. The device applies the changes and restarts.
This takes approximately 1 minute to complete. When the device has finished
restarting, the Ready and LAN LEDs on the front view are lit green.
Tip: Record and retain the IP address and subnet mask you assign the device.
Do the same when defining a new username or password. If the Web interface is
unavailable (for example, if you’ve lost your username and password), use a
BootP/TFTP configuration utility to access the device, “reflash” the load and reset the
password.
5. Disconnect your PC from the device or from the hub / switch (depending on the
connection method you used in step 1 above).
6. Reconnect the device and your PC (if necessary) to the LAN.
7. Restore your PC’s IP address & subnet mask to what they originally were. If
necessary, restart your PC and re-access the device via the Web interface with its
new assigned IP address.