AU Infobar C01, Основное руководство

Страница: 91 / 96

89
~ ~ ~ ~<MFZ>
shx12_e_15.fm
[89/90]
Appendix/Index
Troubleshooting
Trouble Detail
Cannot turn on the
power by pressing
f
.
•
Is the battery pack charged? (
z
P.18)
•
Is the battery pack attached properly? (
z
P.11)
•
Is the jack of the battery pack clean?
•
Did you hold down
f
? (
z
P.20)
The power is turned
off automatically.
•
Is there enough power left in the battery pack?
(
z
P.18)
The power is turned
off while the wake-up
logo is displayed.
•
Is there enough power left in the battery pack?
(
z
P.18)
Cannot make calls.
•
Is the power turned on? (
z
P.20)
•
Is an au IC-Card inserted? (
z
P.14)
•
Did you enter the correct phone number? (Did you
enter the phone number starting with the area
code?) (
z
P.41)
•
Did you tap
Call
after entering a phone number?
(
z
P.41)
•
Did you set the correct setting in
Area settings
?
(
z
P.86)
Cannot receive calls.
•
Is the INFOBAR C01 within the service area or in a
location where the signal is strong? (
z
P.31)
•
Is the power turned on? (
z
P.20)
•
Is an au IC-Card inserted? (
z
P.14)
•
Did you set the correct setting in
Area settings
?
(
z
P.86)
(out of service
area indicator)
appears.
•
Is the INFOBAR C01 within the service area or in a
location where the signal is strong? (
z
P.31)
•
Is your finger etc. off the area around the internal
antenna? (
z
P.10)
•
Did you set the correct setting in
Area settings
?
(
z
P.86)
Display and charging/
incoming indicator
illuminate or flash, but
ring tone does not
sound.
•
Is the ring tone volume set to other than minimum?
•
Is Manner mode disabled? (
z
P.44)
Cannot charge the
battery pack.
•
Are the charging devices connected properly?
(
z
P.18)
•
Is the battery pack attached properly? (
z
P.11)
•
If you use Fast transfer mode, make sure the USB
driver is installed to the PC.
For the USB driver and install manual, refer to the
Support page in SH DASH (http://k-tai.sharp.co.jp/
support/).
Cannot operate key/
touch panel.
•
Is the power turned on? (
z
P.20)
•
Restart the INFOBAR C01. (
z
P.20)
Cannot operate touch
panel as intended.
•
Check the proper operation of touch panel. (
z
P.22)
•
Restart the INFOBAR C01. (
z
P.20)
auIC card(UIM) error.
is
displayed.
•
Is an au IC-Card inserted? (
z
P.14)
•
Is a proper au IC-Card inserted? (
z
P.14)
A message indicating
that charging is
necessary appears.
•
The battery pack is almost empty. (
z
P.18)
Calls are answered
automatically.
•
Is Answering memo disabled? (
z
P.44)
•
Is Manner mode disabled? (
z
P.44)
Battery usage time is
short.
•
Is the battery pack charged enough? (
z
P.18)
•
Make sure the battery does not approach the end of
its service life.
•
Make sure the INFOBAR C01 is not left in the place
for a long period where
(out of service area
indicator) appears. (
z
P.31)
•
Suspend the functions not being used. (
z
P.32)
When making a call, a
beeping sound is
heard from the
earpiece and a
connection cannot be
established.
•
Are you within the service area or in a location where
the signal is strong? (
z
P.31)
•
The wireless line is busy or the other party is on
another line. Try again later.
Display is dark.
•
Is
VeilView
disabled? (
z
P.32)
•
Make sure the temperature of the INFOBAR C01 is
not high.
When the temperature is high, the backlight of the
display automatically becomes dark to control heat
generation of the INFOBAR C01.
Trouble Detail
shx12_ue.book 89 ページ ２０１２年２月１６日 木曜日 午後２時５６分