ATTO Technology SC 5550E, Инструкция по установке и эксплуатации

Страница: 33 / 87

27
6 Make any changes.
• System name : the system name is a unique
8-character identifier which is displayed at
the top of each screen. You may find this
useful if you are managing multiple ATTO
devices from a single workstation.
• Time and date : use a remote time server to
set the time and time zone, or manually set
the time and date. Refer to Date, Time, Time
Zone in
Appendix D .
• Fibre Channel : change the data rate or the
connection mode for each FC port. Refer to
FCDataRate and FCConnMode in
Appendix
D . (Not available for the SC 8250)
• Assign a hard address: refer to FCHard
and FCHardAddress in Appendix D . (Not
available for the SC 8250)
• Establish Access through FC Ports :
change whether all drives are to be used for
multipathing, or if different node names
should be created for each port. (Not
available for the SC 8250)
• Establish SAS Multi-Address Mode:
modify how target SAS addresses are to be
presented on the PHYs. Set this to disabled
to report the same address on each PHY
only when using an ATTO ExpressSAS 6Gb
host adapter in the host. (Not available for
the 5550 or 8550)
• Ethernet management port : change
whether or not you use DHCP for an IP
address, subnet mask and gateway, or
manually change these parameters and set a
DNS server address.
IPv6 Address , Prefix
Length and Gateway are also set here.
Refer to IPDHCP in Appendix D .
• CacheAssure options: see CacheAssure
on page 36.
• Audible Alarm: enable, disable or clear the
alarm. See Audible Alarm on page 35.
• When you have completed your changes,
click on Commit .