ControllerModel (Supported In-Band)
Reports the specific model and firmware information to the CLI.
get ControllerModel
ControllerName (OEM Configurable, Supported In-Band)
Provides a descriptive ASCII name assigned to the unit. This field
is used by applications to identify individual units. The specified
name can be up to a maximum of 32 characters. If the name
contains spaces, it must be enclosed in quotation marks. Unlike
other non-immediates, changes to ControllerName take effect
immediately.
set ControllerName [name]
get ControllerName
CoreDumpInfo (Supported In-Band)
Displays information concerning a core dump stored by a prior
fault.
CoreDumpInfo
DataMoverStats (Supported In-Band)
Displays statistics on aggregate data copied by the Data Mover.
Shows the previous hour and minute. Use "all" to display
statistics over the entire 24 hour period.
get DataMoverStats [all]
Date (Supported In-Band)
Date sets/displays the current date. The date range is
01/01/2000 to 12/31/2099.
set Date [MM/DD/YYYY]
get Date
DeleteAllMaps (OEM Configurable)
Removes all mapped devices from the map table. Upon the
subsequent POST, if no maps are present the default maps will be
loaded.
DeleteAllMaps
DisplayInitiators (Supported In-Band)
Displays the FC Port world-wide name of the connected initiators.
DisplayInitiators
DumpCLILog (Supported In-Band)
Dumps the contents of the CLI command log to the current CLI
session. The column "EvLog#" is the current Event Log number as
seen in DumpEventLog. The keyword "EXCEPT" indicates an
exception occurred while processing the command, and the
keyword "RESTART" indicates the unit was restarted.
DumpCLILog <NumEntries | all>
DumpConfiguration (Supported In-Band)
Dumps system's configuration.
DumpConfiguration
DumpEventLog
DumpEventLog can be used to dump the contents of the event
log to an RS-232 or SSH session. With no parameters, the last
2048 entries will be displayed. The optional parameter "all"
specifies all entries will be displayed. An optional numeric
parameter specifies the maximum number of entries to display
from the end of the log.
DumpEventLog <NumEntries | all>
EmailFromAddress (OEM Configurable, Supported In-Band)
EmailFromAddress configures the email address that this system
will use to talk to the email server. Full email address is a fully
qualified Internet email address, not more than 128 characters
long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify (OEM Configurable, Supported In-Band)
EmailNotify turns on and off email notification. Default is
disabled.
set EmailNotify [enabled | disabled]
get EmailNotify
EmailNotifyAddress (OEM Configurable, Supported In-Band)
EmailNotifyAddress configures notification addresses. Index is a
number between 1 and 5, inclusive. Full email address is a fully
qualified Internet email address, not more than 128 characters
long. The level can be "all", "informational", "warning", "critical"
or "none". This is the minimum level of severity in order for the
event to trigger an email notification.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress <index | all>
EmailPassword
