8
SPRINTER MOBIL - HYMAX PRO 08.12.2015 20110005 OPI
- Remove the front cover hood (1)
- Loosen and remove the sealing screw (5) of the
oil tank
5 Oil illing opening
026
•
Fill new hydraulic oil (e.g. HLP 32). About 8 litres
are needed.
•
Provide an on-site electrical connection of 3 ~/N
+ PE, 400 V, 50 Hz, fuses with 16 A, slow.
•
Connect the electric cable to the customer-pro-
vided mains breaker (e.g. a Cekon plug).
003
•
Turn on main switch (2) and press the „LIFT“
button (3).
!
If the lift does not move upwards after a few
seconds, the direction of rotation of the motor
is incorrect. Swap 2 phases on the plug.
•
Then press the „LIFT“ button (3) again and rai-
se and lower the lift to its limit positions several
times without load. This will largely ventilate the
hydraulic system.
4.3 Changing the assembly location
•
To operate the lift, it must be raised about
500 mm so that the back wheel axes (9) and
guide roller (6) can be engaged.
6 Guide roller
004
7 Torsion shaft
8 Towing bar
9 Wheel axles
•
Place the guide rollers (6) over the torsion shafts
(7). Then push them until the tappet (10) is
located in the notch (11) of the guide
roller.
6 Guide roller
005
10 Tappet
11 Notch
19 Guide roller holder
•
The wheel axles (9) are in the lower plate of the
lift (12).
9 Wheel axle
019
12 Wheel axle storage
i
To simplify mounting, it may be necessary to
raise or lower the lift a little.
Then lower the lift completely. Hang the tow
bar (8) into the guide roller (6) and the lift can then
be moved.
5
8
9
6
7
19
6
11
10
12
9
