20110005 OPI 08.12.2015 SPRINTER MOBIL - HYMAX PRO
11
010
5.1 Lifting the vehicle
!
Warning! The hydraulic lines may not be driven
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
!
The total centre of mass must be considered.
i
If required, use the ramps for safe acceptance
of the vehicle.
•
Secure the vehicle against rolling; pull the hand
brake, engage the gears.
•
Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
•
Switch on controls. Turn the main switch (2) to
position „1“ (see igure 007).
•
Position polymer overlays below the points spe-
ciied by the vehicle manufacturer. The polymer
overlays may not be placed on edge, otherwise
the vehicle could fall.
•
Lift the vehicle. Push the „LIFT“ (3) button.
•
If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the po-
lymer overlays.
•
Raise the vehicle to the desired working height.
•
Then position the operating unit in such a way
that the lexible hose package (protective and
hydraulic hose) cannot be damaged by external
inluences (such as being driven over by the load).
5.2 Lowering the vehicle
!
Warning! The hydraulic lines may not be driven
over. This can lead to damage and, if leaks re-
sult, even to the lift sinking.
•
Inspect the hazardous area. No person or object
may stand in the working area of the lift, or on the
lift.
!
The vehicles cannot be lowered into the lowest
position without wheels. Otherwise the lift can-
not raise the load using its own force. The vehi-
cle could be damaged.
015
•
Lower the vehicle to the desired working height.
Push the „LOWER“ button (4) (see igure 007).
•
The system is equipped with an optional CE-STOP
During „LOWER“ (4) to the lowest position, the
system stops at a height of 300 mm.
To allow the system to lower further, it is necessa-
ry to release the „LOWER“ button (4) and press it
again.
A signal tone sounds until the system has rea-
ched the lowest position.
•
The entire lowering process must be observed.
•
If the lift is in the detectable lowest position, re-
move the polymer overlays and drive the vehicle
from the lift.
