Atlas 12AWFSL, Руководство по установке и эксплуатации

Страница: 34 / 82

Installation 34 12AWFSL
• Set ADJ/WORK selector into the position “WORK”;
• Lower and raise the runways at least 3 times to check the level of runways.
If not leveled, repeat above procedure.
7.8.3 Feeding Oil And Bleeding – Wheel Free Jacks
• Set MAIN/JACK selector into the position “ ”;
• Be sure ADJ/WORK selector is into the position “WORK”;
• Turn off both leveling cocks;
• Press the lifting button: the jack P2 (the master jack on the runway P2)
will be raised;
• Keep pressing the lifting button to raise the jack P2 until it reaches the
maximum height;
• Keep pressing the lowering button to lower the jack P2 completely;
• Raise the jack P2 again until it reaches the maximum height;
• Set ADJ/WORK switch into the position “ADJ”
• Turn on the leveling cutoff cock 2;
• Press the lifting button to raise the jack P1 (the slave jack on the runway
P1) until it reaches the maximum height;
• Keep pressing the lowering button to lower the jack P1 completely;
• Repeat raise and lower the jack P1 completely at least 5 times;
• Raise the jack P1 to the same height as the jack P2;
• Turn off the leveling cutoff cock 2;
• Set ADJ/WORK selector into the position “WORK” after bleeding;
• Lower and raise both jacks at least 3 times to check the level. If not
leveled, repeat above procedure.