Atlas 12AWFSL, Руководство по установке и эксплуатации

Страница: 33 / 82

Installation 33
12AWFSL
• Set MAIN/JACK selector into the position “ ”;
• Open the top cove of the control unit,
set ADJ/WORK selector into the position
“WORK” (ref. Fig. 18);
• Open the rear cover of the control unit,
turn off both leveling cocks placed on
the hydraulic unit (ref. Fig. 19);
• Verify that the motor direction of
rotation is that shown on the motor
arrow label by pushing the lifting
button. IF MOTOR GETS HOT OR
SOUNDS PECULIAR, STOP IMMEDIATELY
AND RECHECK THE ELECTRIC
CONNECTIONS;
7.8.2 Feeding Oil And Bleeding - Runways
Pay much attention: refi ll the oil if not enough during this
procedure. After bleeding, make sure to reset ordinary
operating conditions. Lift cannot work properly if a leveling
cutoff cock is opened.
• Be sure ADJ/WORK selector is into the position “WORK”;
• Press the lifting button, the runway P1 (the master runway: the left side
from the view toward the vehicle head) will be raised only;
• Keep pressing the lifting button to raise the runway P1 until it reaches the
maximum height;
• Press the lowering button to lower the runway P1 completely;
• Raise the runway P1 again until it reaches the maximum height;
• Set ADJ/WORK selector into the position “ADJ”;
• Turn on the leveling cutoff cock 1;
• Press the lifting button to raise the runway P2 (the slave runway: the right
side from the view toward the vehicle head) until the platform reaches the
maximum height. Pay attention to re fi ll the oil if not enough;
• Press the lowering button to lower the runway P2 completely;
• Repeat raise and lower the runway P2 completely at least 5 times;
• Raise the runway P2 to the same height as the runway P1;
• Turn off the leveling cutoff cock 1;