Atlas Copco XAS 130 DD7 C3 APP, Инструкция по эксплуатации

Страница: 60 / 116

- 60 -
Control panel (generator) Earth pin
As soon as the generator is switched on, the automatic
control system will continuously check for electric
load in order to rev up the engine from idle to nominal
speed only when needed. This saves fuel and reduces
emissions.
What is more, with the current continuously
monitored, a consumer having just been switched on
is temporary disconnected from the generator to be
re-connected as soon as the engine reaches nominal
speed. This is a safety mechanism to protect generator
and engine below nominal speed.
Operation with automatic control switch S8
“OFF”

Switch generator main switch S7 “ON”.

Generator is disconnected from socket.

Engine reaches nominal speed.

Generator is re-connected after 4 secs.

Power is now available until the generator main
switch S7 is turned “OFF”.
Operation with automatic control switch S8
“ON”

Switch generator main switch S7 “ON”.

Generator is disconnected from socket.

Engine reaches nominal speed.

Generator is re-connected after 4 secs.

If a consumer is connected, the engine goes on for
60 secs. before falling back to idle speed.

Generator is in standby. As soon as any consumer
is switched on, the routine is repeated from step 2.
H3 Lamp (green, power ON)
S7 Switch (generator - compressor)
H4 Lamp automatic control system
S8 Switch automatic control system
X1 Socket 110 V/ 32 A
X2 Socket 110 V/ 16 A
X3 Socket 110 V/ 16 A
GND Terminal earth cable
Before switching on the generator,
always place the earth pin in position.
Check the cable connection between
earth pin and the GND-terminal on the
unit.
110V WITH AUTOMATIC CONTROL SYSTEM (OPTION)
(X3) (H3/S7) (H4/S8) (GND) (X2) (X1)
Avoid high inductive loads (e.g.
welding). High inductive loads can
damage the generator.
min 400