Astro Machine AstroJet M2, Руководство оператора

Страница: 2 / 90

SAFETY PRECAUTIONS
THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY.
OBSERVE SAFETY RULES WHEN OPERATING THE M2 PRINTER.
BEFORE USING PRINTER, READ THIS MANUAL CAREFULLY AND FOLLOW
RECOMMENDED PROCEDURES, SAFETY WARNINGS, AND INSTRUCTIONS:

Keep hands, hair, and clothing clear of rollers and other moving parts.

Avoid touching moving parts or materials while machine is in use. Before clearing a jam, be
sure machine mechanisms come to a stop.

Always turn machine off before making adjustments, cleaning machine, or performing any
maintenance covered in this manual.

Power cord and power supply supplied with machine. Plug it into a properly grounded, easily
accessible wall outlet near machine. Failure to properly ground machine can result in severe
personal injury and/or fire.

Power cord/wall plug are primary means of disconnecting machine from power supply.

DO NOT use an adapter plug on power cord or wall outlet.

DO NOT remove ground pin from line cord.

DO NOT route power cord over sharp edges or trap it between furniture.

Avoid using wall outlets that are controlled by wall switches or shared with other equipment.

Make sure there is no strain on power cord caused by jamming it between equipment,
walls or furniture.

DO NOT remove covers. Covers enclose hazardous parts that should only be accessed by a
qualified service representative. Report any cover damage to your service representative.

This machine requires periodic maintenance. Contact your authorized service representative
for required service schedules.

To prevent overheating, do not cover vent openings.

Use this equipment only for its intended purpose.
In addition, follow any specific occupational safety and health standards for your workplace or area.
This manual is intended solely for the use and information of Astro Machine Corp., its designated
agents, customers, and their employees. The information in this guide was obtained from several
different sources that are deemed reliable by all industry standards. To the best of our
knowledge, that information is accurate in all respects. However, neither Astro Machine Corp. nor
any of its agents or employees shall be responsible for any inaccuracies contained herein.
AstroJet
TM
is a registered trademark of Astro Machine Corp.
Memjet
®
is a registered trademark.
All other trademarks are the property of their respective holders.
All rights reserved. No part of this book may be reproduced or transmitted in any form or by any means, electronic or mechanical,
including photocopying, recording, or any information storage and retrieval system, without permission in writing from the publisher.