Astro Machine AstroJet M2, Руководство оператора, Страница: 30 / 90

SECTION 2
INSTALLING PRINTER
24
4. Wet Printhead Surface. ( Ensures that
Printhead will prime correctly ). Open Top
Cover. Release and lift two latches at same
time to raise Print Engine Clamshell.
Moisten Printhead nozzles using
distilled water and a damp, lint-free cloth,
wiping end to end. (
Gray strip located below
orange strip .)
Close and latch Print Engine Clamshell.
CAUTION
HOLD ONTO BOTH LATCHES
WHEN OPENING AND CLOSING
PRINT ENGINE CLAMSHELL TO
PREVENT DAMAGE.
DO NOT ALLOW CLAMSHELL TO
DROP OR SLAM CLOSED.
TO PREVENT DAMAGE TO INK
LINES, A STOP LIMITS RAISING
CLAMSHELL MORE THAN 60°.
5. Close Printhead Latch [6] . Printer starts
up and primes ink into Printhead. ( May take a
few minutes .) Make sure that ink is flowing
through hoses.
6. Watch Toolbox screen. Notice that some information is
in
red . As Printer circulates ink and primes system these
fields should all turn black .
7. When Printer stops processing and all fields in System
Status are
black , Printer is ready for use.
Close Top Cover.
NOTE: Printer may take up to 12 minutes to set itself up
during initial startup. This is normal.