Astro Machine AstroJet M2, Руководство оператора

Страница: 59 / 90

SECTION 4
MAINTENANCE
53
6. Wet Printhead Surface. ( Ensures
Printhead will prime correctly .)
Open Top Cover. Release and lift two
latches (
at same time ) to raise Print
Engine Clamshell.
Moisten Printhead nozzles using
distilled water and a damp, lint-free
cloth, wiping end to end.
( Gray strip
located below orange strip .) Close and
latch Print Engine Clamshell.
CAUTION
HOLD ONTO BOTH LATCHES
WHEN OPENING AND CLOSING
PRINT ENGINE CLAMSHELL TO
PREVENT DAMAGE.
DO NOT ALLOW CLAMSHELL TO
DROP OR SLAM CLOSED.
TO PREVENT DAMAGE TO INK
LINES, A STOP LIMITS RAISING
CLAMSHELL MORE THAN 60°.
7. Close Printhead Latch [6] . Printer starts up and
primes ink into Printhead. ( May take a few minutes .)
Make sure that ink is flowing through hoses.
If air bubbles appear, you may have to tap lines
or click
“Circulate Ink”
in Printer Toolbox to
purge them.
8. Watch Toolbox screen. Notice that some information is in
red . As Printer circulates ink and primes system these fields
should all turn black .
9. When Printer stops processing and all fields in System Status
are
black , Printer is ready for use. Close Top Cover.
IMPORTANT!
CHECK INK TANKS. PRINTER MAY NOT FULLY
REPRIME IF TANKS ARE LESS THAN 1/3 FULL.
NOTE: Printer may take up to 12 minutes to set itself up during
initial startup. This is normal.