Astro Machine AstroJet L1, Руководство оператора

Страница: 30 / 86

SECTION 3
OPERATING PRINTER
24
Media Tab
Media Tab shows the the type of media the Printer is
configured to run and allows minor changes to the
positioning and cutting of the media.

Media – Displays the type of media currently
selected for the Printer. Press Refresh to update
the display.

Printing Adjustments – ( Top, Left and Bottom
Adjustments plus Max Page Width and Interpage
Gap.
) Make minor positioning changes to the print
area in relation to the media if needed.
NOTE: Printing Adjustments only works when
Print Area is less than full print width (
less than
8.5"/215.9mm wide ). See “Using Media Tab
Printing Adjustments” on next page.
Stitch
– When selected, prints the entire document
as a single page ( no gaps ).
Label Frequency – Allows Printer to ignore a set
number of gaps between labels. This is particularly
useful when the labels are different shapes and the
Printer sensor may not sense the edge of second label correctly. (
For example, printing both front and back
bottle labels in one pass .) A label frequency of “1” reads the gap between every label. A setting of “2” will
ignore the gap between the two labels [A] . ( In effect, the Printer
“
sees
”
the two labels as one label ). The
Label Frequency can be set from 1-8 .
NOTE: Using this feature requires that the job be set up as one label in the layout software, so
dimensions (
including gap ) must be accurate.

Page Cutting – Sheets per Cut: Set the number of labels ( sheets ) between cuts. Example: 1 = cut after
every label. 5 = cut after every fifth label. NOTE: Since End of Job Cut will also be active, last cut may
have fewer labels than set Pages per Cut number depending on total number of labels you are printing ( i.e.
you print a total of 23 labels set to cut after every fifth label, you will have 4 sets of 5 labels, 1 set of 3. )
End Job Cut: When checked, cuts the end of the media after the job finishes printing.
Cutter Offset: Allows fine tuning of the cut line position after making image positioning adjustments.

Units – Set measurements to be in Inches or Millimeters.
Example of a Label
Frequency of “2”