ASP Sterrad Velocity Reader, Руководство пользователя

Страница: 20 / 82

3
Overview
14 STERRAD VELOCITY Reader User’s Guide
Sleep Mode
After a user configurable idle time (default 15 minutes), the reader will go into a
sleep mode which dims the touch screen backlight while continuing to incubate BIs. The
reader enters sleep mode to preserve energy and prolong the life of the touch screen
backlight. The length of idle time which activates sleep mode can be adjusted in the
Utilities Menu under System Configuration. Refer to “Access Levels and Administrator
Tasks” (Chapter 7) for information on how to change these settings. The reader will wake
from sleep mode by touch screen input, USB device input, inserting or removing a BI,
and on detection of an error.
Touch Screen
The full color 1024 x 500 pixel resolution capacitive touch display can be used
with bare hands or while wearing latex, nitrile, vinyl, and polyisoprene medical gloves.
Barcode Scanner
The barcode scanning mechanism makes entering BI information quick and
simple. It is located on the right front of the reader. It uses two LEDs for illumination and
aiming, making it possible to scan a barcode in a wide variety of lighting conditions. In
order to scan a BI barcode, hold the BI approximately 10 cm (4 in.) from the scanner with
the barcode facing the scanner. Align the barcode on the cap label with the center of the
red light produced by the barcode scanner. Slowly rotate the BI back and forth until an
audible beep is heard. If the barcode cannot be read, the device will beep five times.
The reader can also be equipped with a handheld USB barcode scanner. Attach
the handheld barcode scanner to a USB port in the rear of the device. To activate the
attached scanner, go to Utilities > System Config, and under Barcode Scanner In Use
select USB. Once the external barcode scanner is activated, the internal barcode
scanner is disabled.
Power Adapter
The reader comes with an AC power adapter with an input of 100V to 240V at
50–60Hz and an output of 12V DC at 5A maximum. It has four sets of interchangeable
prongs making it easy to switch between plug types A, C, G, and I. Simply remove the
blanking plate and attach the prongs which fit the wall outlet at the install location and
then connect the adapter to the wall and the back of the reader.