Aruba 4100i Switch Series | Installation and Getting Started Guide
69
1. For JL817A, plug the included power cords into the or power supply's power connector and into a
nearby AC/DC power source.
2. For JL818A, plug the included power cords into the switch's power connector and into a nearby AC
power source.
3. Secure the power cord plug with the cable tie.
4. Check the LEDs. See
Chassis LEDs and buttons on the front of the switch on page 23
Setup for Initial Configuration
Using an out-of-band serial console:
Use a workstation configured with suitable VT-100 terminal
emulation software and connect the workstation to the switch’s RJ-45 or USB-C console port.
Connect Network Cables
Connect the network cables from the network devices or your patch panels to the RJ-45 port on the switch
or to any transceivers you have installed in the switch. See
for further details.
Connecting Cables to Transceivers
If you have any transceivers installed in the switch, the type of network connections you will need to use
depends on the type of transceivers installed. See
Cabling and Technology Information
For transceiver ports, and in general for all the switch ports, a network cable from an active network device is
connected to the port. If the port LED does not come on when the network cable is connected to the port,
see
in the Troubleshooting chapter.
Ports are enabled by default.
