Connect the Switch to a Power Source
|
68
Figure 2
Mounting the switch in a four-post rack
5. Secure the rear-post brackets to the rack rear posts using two number 10-32 screws.
Install Transceivers (optional)
Hold the transceiver by its sides and gently insert it into the switch until it clicks into place. When a
transceiver is inserted, the switch authenticates it. This can take 1-3 seconds, with the worst case being 5
seconds.
n
The Aruba transceivers are Class 1 laser devices. Avoid direct eye exposure to the beam coming from the
transmit port.
n
The transceivers operate only at full duplex. Half duplex operation is not supported.
n
Use of supported genuine Aruba transceivers is always recommended. Non-Aruba SFP/SFP+ transceivers can
be used in unsupported transceiver mode, but no support or warranty will be provided. Should you require
additional transceivers, contact your Aruba sales representative or an authorized reseller.
n
Always disconnect the network cable from a transceiver before installing it in the switch.
n
You can install or remove a transceiver from an SFP slot without having to power off the switch.
n
The switch will derate to an operating temperature range of 0ºC to 50ºC when using commercial grade
transceivers.
n
For more transceiver support information for your switch model, see the
Transceiver Guide
.
Connect the Switch to a Power Source
