Artel DigiLink DLC170, Установка и эксплуатация

Страница: 40 / 50

30 DLC170 Function Modules Installation and Operations Manual
DLC170 Function Modules
The rotary switch is calibrated with the input terminated in 600 Ohms. Table 10 describes the rotary switch
SW4 configuration options.
Table 10. Rotary Switch SW4 Settings
Position
Peak Audio Level
Position
Peak Audio Level
0 +10 dBm 4 +18 dBm
1 +12 dBm 5 +20 dBm (default)
2 +14 dBm 6 +22 dBm
3 +16 dBm 7 +24 dBm
Installing and Cabling the DLC170DA
Follow the instructions located in the following sections to install and cable the DLC170DA:
• Installing the DLC170 Modules and SFP (page 13)
• Cabling the DLC170 Modules (page 15)
Monitoring the DLC170DA Operations
This section describes how to monitor the DLC170DA operations using the front panel LEDs and the monitor
(see Figure 19 ).
Figure 19. DLC170DA Status LEDs and Monitor Connector
Note:
You can also use Artel’s element management system, DL Manager, to monitor the module
operations (see the DL Manager Setup and Operations Manual ).
This section contains the following topics:
• Understanding the DLC170DA Status LEDs (page 31)
• Using the DLC170DA Monitor Jack (page 34)