Artel DigiLink DLC170, Установка и эксплуатация

Страница: 24 / 50

14 DLC170 Function Modules Installation and Operations Manual
DLC170 Function Modules
5. Install the SFP into the DLC170 (handle on top as shown in Figure 8 ). Push the SFP into the socket located
on the right side of the function module until it is firmly seated into the socket.
Note:
(DLC170AD only) When the “SFP missing” alarm is enabled and you do not install an SFP, the
TX status LED located on the DLC170AD front panel flashes. See Table 6 for other LED status
indications.
Note:
(DLC170DA only) When the video source is set to “SFP optical receiver” and you do not
install an SFP, the RX status LED located on the DLC170DA front panel flashes. See Table 11
for other LED status indications.
6. Repeat this procedure for each DLC170 module that you are installing in the host chassis.
Figure 8. DLC170 Module and SFP Installation
SFP
(handle on top)
DLC170 Module
Mounting Screws
(2)