Artel DigiLink DLC170, Установка и эксплуатация

Страница: 20 / 50

10 DLC170 Function Modules Installation and Operations Manual
DLC170 Function Modules
Figure 4 shows the DLC170AD configuration switch SW2 located on top of the PCB.
Figure 4. DLC170AD Configuration Switch SW2
Table 3 describes the DIP switch SW2 configuration options. The factory-set configuration settings are shown
in bold type.
Table 3. DIP Switch SW2 Settings
Function Selected Operation
Position
S1 S2 S3 S4 S5 S6 S7 S8
Audio Embed Enabled
ON
Disabled OFF
Reserved Must be ON
ON
Audio
Destination Group 1 ON ON
Group 2 OFF ON
Group 3 ON OFF
Group 4 OFF OFF
Audio Mode 24 bits ON
20 bits OFF
Reserved Must be ON ON
SFP Alarms Enabled
ON
Disabled OFF
EMS Override Enabled: DL Manager can change
the DLC170AD module
configuration.
ON
Disabled: DL Manager cannot
change the DLC170AD module
configuration.
1
OFF
1. If the module is operating in EMS Override mode, as indicated by a green OK LED on the front panel, thenthe EMS
Override DIP switch has no effect until you use DL Manager to take the module out of override mode and set it to local
mode (see the
DL Manager Setup and Operations Manual ).