Arista AP-3500, Руководство пользователя

Страница: 35 / 48

32
Suspend Type (Stop Grant)
If this item is set to the default Stop Grant, the CPU will go into Idle Mode during power saving mode.
MODEM Use IRQ (3)
If you want an incoming call on a modem to automatically resume the system from a power-saving
mode, use this item to specify the interrupt request line (IRQ) that is used by the modem. You
might have to connect the fax/modem to the motherboard Wake On Modem connector for this
feature to work.
Suspend Mode (Disabled)
Use this item to enable or disable the suspend mode function.
HDD Power Down (Disabled)
When enabled, the hard-disk drives will power down after a set time of system inactivity. All other
devices remain active.
The Choices: Disabled (default), 1 Min, 2 Min, 3 Min, 4 Min, 5 Min, 6 Min, 7 Min, 8 Min, 9 Min, 10
Min, 11 Min, 12 Min, 13 Min, 14 Min, 15Min.
Soft-Off by PWR-BTTN (Instant-Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create a software
power down. In a software power down, the system can be resumed by Wake Up Alarms. This
item lets you install a software power down that is controlled by the power button on your system.
If the item is set to Instant-Off, then the power button causes a software power down. If the item
is set to Delay 4 Sec. then you have to hold the power button down for four seconds to cause a
software power down.
PWRON After PWR-Fail (On)
This item enables your computer to automatically restart or return to its last operating status after
power returns from a power failure.
Wake Up by LAN (Disabled)
This item specifys whether the system will be awakened from power saving modes when activity
or input signal of the specified hardware peripheral or component is detected.
Power On by Ring (Disabled)
The system can be turned off with a software command. If you enable this item, the system can
automatically resume if there is an incoming call on the Modem. You must use an ATX power supply
in order to use this feature.
Video off Method (DPMS)
This item defines how the video is powered down to save power. This item is set to DPMS (Display
Power Management Software) by default.
Video off In Suspend (Yes)
This option defines if the video is powered down when the system is put into suspend mode.