Ariens Pro 28 EFI CE, Руководство по обслуживанию, Страница: 67 / 84

EN – 66
8. Reinstall track drive wheel and reinstall track. See
Install Track Drive Wheel
on page 60 and
Install Track
on page 61.
9. Return unit to operating position.
10. Model 926337: Adjust track tension. Refer to
Operator’s Manual for adjustment procedure.
11. Fill fuel tank and reconnect spark plug wire.
IMPORTANT:
Check all adjustments after first use.
Remove Right Bearing
IMPORTANT:
Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See
Service Position
on
page 7.
4. Remove track drive wheel and remove track. See
Remove Track Drive Wheel
on page 60 and
Remove
Track
on page 61.
5. Remove bottom cover. See
Remove Bottom Cover
on
page 14.
See Figure 160 and Figure 161.
6.
Remove E-ring from right axle end.
7.
Models 926060, 926069, 926338:
Remove hubs from
axle ends.
Model 926337:
Remove flat steel washers from axle
ends.
8. Remove long axle from differential gear.
WARNING:
AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Draining Fuel System
on page 7.
Make sure unit is secure and will not tip.
Figure 160
Models 926060, 926069, 926338