Arctic Cat ZR 6000 R SNOCROSS 2015, Руководство оператора

Страница: 57 / 126

53
RS044A
9. Lubricate the inner lips of the crankshaft oil seals
with grease; then slide the seals and rubber spacer
onto the crankshaft making sure the spring side of
each seal faces the center of the crankshaft.

NOTE: There is a MAG-side seal and a PTO-side
seal.
10. Apply oil to the crankshaft bearings; then install
the crankshaft into the upper crankcase half. Be
sure the alignment hole in each bearing is posi-
tioned over its respective retaining pin in the
crankcase; then seat the crankshaft.
RS045A

NOTE: To check the bearing for proper position,
place the point of a sharp tool into the dimple
found in the bearing race. Strike the tool with the
palm of the hand in either direction. If the bearing
moves, it isn’t positioned correctly and must be
rotated until it drops onto the retaining pin.
11. Position the two center seal rings with their end
gaps 180° apart (up on one and down on the
other).
CM036A
12. Apply a thin coat of Three Bond Sealant (p/n
0636-070) to the entire bottom half of the crank-
case sealing surface.
FC071

NOTE: Use only Arctic Cat Three Bond Sealant
(p/n 0636-070) to seal the crankcase halves.
13. Assemble the crankcase halves making sure that
the crankshaft gear and water pump driveshaft
gears mesh. Rotate the crankshaft one full turn to
align the crankshaft gear and pump driveshaft.
14. Install the crankcase cap screws (coated with blue
Loctite #243) securing the crankcase halves.
15. Tighten the three 6 mm cap screws to 96 in.-lb and
the ten 10 mm cap screws using two steps (step 1
= 13 ft-lb; step 2 = 31 ft-lb) using the pattern
shown.
0738-202
CAUTION
If the bearings are not properly seated during assem-
bly, the crankcase halves will not seal tightly and
severe engine damage will result.