Arctic Cat ZR 6000 R SNOCROSS 2015, Руководство оператора

Страница: 109 / 126

105
0746-096
3. Install the bulb and retainer; then rotate the retainer
clockwise until it properly locks in place.
4. Install the rubber grommet; then connect the head-
light harness connector to the bulb.
5. Check headlight aim (see Adjusting Headlight Aim
in this sub-section).
Installing Headlight Assembly
1. With the headlight assembly in position, install the
front headlight assembly screws. Engage the side
headlight screws in the slots and tighten until snug.
2. Engage the side console tabs on the headlight assem-
bly; then place the front of the console over the head-
light assembly. and press down until it snaps in place.
3. Install the two screws securing the rear of the con-
sole to the hood. Tighten only until snug.
4. Place the windshield brace assembly into position
and secure to the console with the four screws.
Tighten until snug.
5. Connect the gauge; then connect the electrical
accessory wires.
6. With the windshield in position, secure the windshield
to the frame using the four screws. Tighten securely.
Adjusting Headlight Aim
The headlight can be adjusted for vertical aim of the
HIGH/LOW beam. The geometric center of HIGH beam
zone is to be used for vertical aiming.
1. Position the snowmobile on a level floor so the head-
light is approximately 8 m (25 ft) from an aiming
surface (wall or similar surface).

NOTE: There should be an “average” operating load
on the snowmobile when adjusting headlight aim.
2. Measure the distance from the floor to midpoint of
the headlight.
3. Using the measurement obtained in step 2, make a
horizontal mark on the aiming surface.
4. Make a vertical mark intersecting the horizontal
mark on the aiming surface directly in front of the
headlight.
5. Engage the brake lever lock and start the engine.
Select the headlight dimmer switch HIGH beam
position. DO NOT USE LOW BEAM.
6. Observe the headlight beam aim. Proper aim is when
the most intense beam is centered on the vertical
mark 5 cm (2 in.) below the horizontal mark on the
aiming surface.
7. Adjust the headlight using the adjusting screw on the
backside of the headlight housing until correct aim is
obtained. Shut the engine off; then disengage the
brake lever lock.
0746-807
Ski Wear Bar

NOTE: The skis on the Snocross model are not
equipped with wear bars. Ski wear bars are avail-
able from an authorized Arctic Cat Snowmobile
dealer.
The ski wear bar is a replaceable bar attached to the
underside of the ski. The purpose of the wear bar is to
assist in turning the snowmobile, to minimize ski wear,
and to maintain good steering control. If the snowmo-
bile is operated primarily in deep snow, ski wear bar
wear will be minimal; however, if the snowmobile is
operated on terrain where the snow cover is minimal,
the ski wear bar will wear faster. To maintain positive
steering characteristics, Arctic Cat recommends that
the ski wear bars be checked before each use and
replaced if worn beyond 1/2 of the original diameter.
Ski wear bars are available from an authorized Arctic
Cat Snowmobile dealer.

NOTE: Always check the official rules for the
appropriate wear bars for the event being partici-
pated in.
Removing
1. Raise the front of the snowmobile and place it on a
support stand.
! WARNING
Do not operate the snowmobile unless headlight beam
is adjusted properly. An incorrectly adjusted beam will
not provide the operator the optimum amount of light.
! WARNING
Operating the snowmobile with excessively worn or
missing wear bars may result in a loss of steering con-
trol.