38
CNC System Instruction
When MOVE HOLE option is taken, it needs to change the
MOVE HOLE option
to 1 in the
parameter control
menu, thus
to enables the option. In this way, whenever it is time for piercing operation, the system will prompt an option menu
as shown below:
3.9.1 HOLE
To pierce at the original position, which is often used for boring.
3.9.2 MOVE HOLE
Operator may press
[↑], [↓], [←]
and/or
[→]
key to move the cutting torch to the edge of steel plate; in the meantime, the speed multiply-
ing factor is adjusted to 5% automatically. The system is preheated.
Press [START] key at the end of preheat. The cutting torch will reach the piercing point along a straight line at select-
ed cutting speed and then go on machining.
3.9.3 NO HOLE
Instead of piercing, the system moves through the current piercing position to next, and new piercing prompt appears.
Fig. 3.7 Option dialog box prompted by the system after reach piercing point if edge piercing
method is selected
