8
OWNER QUICK START & RUN
The Boost Button:
The BOOST button increases output to 100%. Use this feature
when a heavier then normal bather load is anticipated.
Press BOOST
once
........................ = 24-Hour Boost
Press and hold BOOST for 8 seconds= 72-Hour Boost
Press BOOST a second time............= Deactivate Boost
Menu and Select Button:
Allows access to the “T
e
st,” “View Setup,” “Owner Options,”
“Maintenance,” and “Installer” menus. The SELECT button
allows the operator to choose program menu options. The
owner / operator should not normally need to access these
features on a regular basis. Consult “Programming” section
or contact factory customer support for additional information.
The CHECK SYSTEM light will flash to warn the DIG-220
may
need attention. A warning message will also be.
displayed
.
Unless deemed a normal condition, per
below,
see troubleshooting section on page 21.
Check System Light:
Flashes if the water flow is insufficient under the
following circumstances:
- When DIG-220 is not set up to control the water
pump (uses an External Timer or Remote Runs
Pump), and DIG-220 is wired to the line side
(hot a
ll
the time).
- If the DIG-220 controls the pump (One-speed Pump),
the light will not flash when the pump is off.
Flashes when salt is low
Flashes when water temperature exceeds 125° F, or
drops below 10° F
Flashes when “PUMP OFF FOR SERVICE”
Purifier Output level ................................................. :
Water Temperature .................................................. :
Cell Status ............................................................... :
Check System Light ................................................ :
Normal Display:
In 1% increments, from 0% to 100%
In Fahrenheit or Celsius
ON
OFF
FIG-2
FIG-3
FIG-4
Purifier
12:00 pm 80F
100%
Purifier
12:00 pm 80F
100%
Purifier
12:00 pm 80F
100%
After 30-minutes of inactivity, the display will go to a “walking dot” screen saver
model. All
functions
such
as chlorine generation, reverse, boost, etc., will continue in the background. Pressing any key
will call
up the normal informational display.
