APV ISOBUS M2, Руководство по эксплуатации

Страница: 46 / 56

46
Problem Cause Solutions
Spread rate is too high or too
low!

Wrong speed.

Linkage sensor switches
during operation.

Seed properties have
changed.

Check the hectare counter on
the controller!

Check the speed!

Calibrate the speed sensor
(not required for GPS sensor).

Check the linkage sensor.

Perform a calibration test.

Reduce the fan speed for the
hydraulic fan.
11 SOFTWARE UPDATE
For a software update, please contact Service at APV, the contact data can be found under Point 2.
12 ACCESSORIES
12.1 EXTENSION CABLE
This cable serves as an extension cable between the APV implement and the
"ISOBUS connection cable" (see Point 4.3 - included with the delivery of an
ISOBUS-PS).
The extension cable is available in two lengths: 2 m and 5 m.
Order number: 00410-2-221 (2 m), 00410-2-220 (5 m)
Figure 37: Symbolic image
PLEASE NOTE!
If multiple extension cables are used together, the electrical power of the
fan can be reduced!
12.2 SPLITTER CABLE APV/EXTERNAL
With this cable, an APV implement and an external implement can be operated
via the ISOBUS.
To do so, the ISOBUS socket is installed on the APV implement. The two AMP
connectors are connected between the APV implement and the "ISOBUS
connection cable" (see Point 4.3 - included with the delivery of an ISOBUS-PS).
Figure 38
PLEASE NOTE!
The short connection must be connected directly to the APV implement.
An extension cable may not be used in between!
Cable length: 0.75 m
Order number: 04000-2-930