APV ISOBUS M2, Руководство по эксплуатации

Страница: 47 / 56

47
12.3 SPLITTER CABLE APV/APV
With this cable, two APV implements can be operated via the ISOBUS.
The cable is connected between an APV implement and the "ISOBUS connection
cable" (see Point 4.3 - included with the delivery of an ISOBUS-PS). The longer
end of the cable is then connected to the second APV implement.
Figure 39
PLEASE NOTE!
An extension cable may not be used in between!
Availability upon request and only as of software version 3.2.0!
Cable length: 2 m
Order number: 04000-2-931
12.4 CALIBRATION BUTTON
The calibration button is integrated directly in the wiring harness of the PS and is installed on
the implement with the integrated magnets. As a result, the calibration test and emptying of
the hopper can be performed directly on the implement.
Order number: 00410-2-185
Figure 40
12.5 LINKAGE SENSOR CHASSIS
Through this sensor, the seeding shaft of the PS can start and stop rotating automatically
when lifting and lowering the implement.
Connection: 12-pin plug on the side of the PS (under the cover)
Order number: 00410-2-173
Figure 41
12.6 LINKAGE SENSOR TOP LINK
Through this sensor, the seeding shaft of the PS can start and stop rotating
automatically when lifting and lowering the implement.
Connection: 12-pin plug on the side of the PS (under the cover)
Order number: 00410-2-169
Figure 42
12.7 LINKAGE SENSOR PULL SWITCH
Through this sensor, the seeding shaft of the PS can start and stop rotating
automatically when lifting and lowering the implement.
Connection: 12-pin plug on the side of the PS (under the cover)
Order number: 00410-2-174
Figure 43