34
Quality for Professionals
15.4 Linkage sensor pull switch
Order number:
Item no.: 00410-2-174
Connection:
12-pin plug on the control box
Cable length:
5 m
With this sensor, the slider on the ES 100 M3 Special can be automatically opened
and closed when lifting and lowering the implement.
Installation position:
By means of a spring (for length compensation) and a chain,
two points that move relative to each other when lifting the
implement can be connected. Through the length change the
switch is activated and thus the seeding shaft is switched off. In
a manner similar to the sensor for the top link lifting unit, the pull
switch can be mounted on the three-point and can be tensioned
on the tractor with with the chain, e.g. on the towing hitch. Now
if the implement is lifted, the distance between the two points
increases and the pull switch actuates the slider. However, the
switch can also mounted parallel to the cylinders,
parallelograms, where with the lift-out procedure a relative
movement between the two points takes place. You can specify
whether spreading should occur with the switch activated or
deactivated.
If the working position is to be turned, the OK button and the ON/OFF button must be
pressed simultaneously when switching on.
The following appears on the display:
Items included:
1 sensor,
1 fastening plate incl. fastening bolts
Three-point linkage
signal Inverted!
Fig.: 20
