Applied Innovation AISwitch AI2524, Руководство пользователя

Страница: 323 / 418

Chapter 13: AI2524 Frame Relay Configuration Steps
August 1997 Page 13-7
2524UM
Set the LMI Keepalive Interval
A keepalive interval must be set to configure the LMI. By default, this
interval is 10 seconds and, per the LMI protocol, must be less than the
corresponding interval on the switch.
z
To set the keepalive interval, type (in interface configuration
mode):
keepalive number
z
To turn off keepalives on networks without an LMI.
no keepalive
Set the LMI Polling and Timer Intervals
You can set various optional counters, intervals, and thresholds to
fine-tune the operation of your LMI DTE and DCE devices. Set these
attributes by performing one or more of these tasks in interface config-
uration mode
z
Set the DCE and Network-to-Network Interface (NNI) error
threshold.
frame-relay lmi-n392dce threshold
z
Set the DCE and NNI monitored events count.
frame-relay lmi-n393dce events
z
Set the polling verification timer on a DCE or NNI interface.
frame-relay lmi-t392dce timer
z
Set a full status polling interval on a DTE or NNI interface.
frame-relay lmi-n391dte keep-exchanges
z
Set the DTE or NNI error threshold.
frame-relay lmi-n392dte threshold
z
Set the DTE and NNI monitored events count.
frame-relay lmi-n393dte events