AP Cumberland Feed-Link 2, Инструкция по установке и эксплуатации

Страница: 18 / 46

18 PNEG-2340 Feed-Link 2
5. Installing the Stand Alone Display Units
Mounting Display and Junction Boxes
The display can be mounted either directly onto the
bin leg or remotely, up to 1000' away, such as inside
a nearby building.
When mounted remotely, a junction box must be
used to extend the load cell wires from the bin to the
display unit. The junction box can be mounted to the
bin leg similar to the display shown.
(See Figure 5C.)
1. Attaching the display unit or junction box to the
bin leg.
a. Take mounting bracket and slide it around
the bin leg. (See Figure 5A.)
b. Attach to leg using 3/8" x 1-1/2" HHCS bolt
and hex nylock nuts. No drilling is required.
(See Figure 5B.)
c. Attach display unit or junction box to the
mounting bracket using the three (3) #10
nuts provided.
Figure 5A Bin Leg Mounting Bracket
Attached to the Bin Leg
Figure 5B Close-Up of Mounting Bracket on Leg
Figure 5C Display Unit Mounted on the Outside of the
Bin Leg (Junction Box Similar)
ENTER CAL
Bracket
Display
unit