PNEG-2340
Feed-Link 2
29
8. Water Meter Option
Optional Water Meter
(One gallon per pulse)
1. Hook water meter wires to the display unit.
a. Run the water meter cable through the
bottom left water tight nut.
b. Remove the terminal strip.
c. Connect 18 AWG shielded, two (2)
conductor cable from the water meter to
the terminal strip in the display unit marked
“water meter”. Connect the black wire to
the left hand terminal and white wire to the
right hand terminal as shown in
d. Replace the terminal strip onto the board.
e. Tighten the water tight nut.
f. Attach the lid and fasten with the supplied
hardware.
2. Water meter input.
The water meter input cannot be accessed
with a display unit. The water meter
information is transmitted via the RS485
network to a Network Master. The water
consumption over the last 24 hours can then
be accessed via the PC program Feed-Link
or a status report that the Network Master
emails out. The water meter input is located on
the two (2) left most positions located at the
bottom of the display unit. The connector can
be removed and wires screwed down and then
the connector placed back on the mounting
pins located on the circuit board. The water
meter cable is to enter the enclosure on the
left most water tight nut on the bottom of the
display unit.
Figure 8A Removing the Terminal Strip from Board
