Anilam 4200T, Руководство пользователя

Страница: 34 / 48

CNC Motion Setup/Testing Utility
P/N 70000634C
All rights reserved. Subject to change without notice.
November 2009
30
Amplifier Test Link
This feature is only for systems equipped with an ANILAM AC Amplifier
(P/N 33001279) and with the Servo Amplifier Communications Cable, P/N
33001389, connected.
This enables/disables the communications monitor. The communications
monitor has two modes of operation: Monitor and Command. Using an
external keyboard, use hot key (
CTRL
+ F7 ) to switch between the two
modes.
Monitor: (Default) During this mode, you can monitor all
communication between the Amplifier and the Control.
Command: During this mode, it not only monitors all communications;
but also, allows you to send direct commands to the
Amplifier.
Reset Amplifier
This feature is only for systems equipped with an ANILAM AC Amplifier
(P/N 33001279) and with the Servo Amplifier Communications Cable, P/N
33001389, connected.
This resets the AC Amplifier.
BackUp Amp Settings
This feature is only for systems equipped with an ANILAM AC Amplifier
(P/N 33001279) and with the Servo Amplifier Communications Cable, P/N
33001389, connected. Refer to “Restore from Backup.”
To backup amplifier parameters:
1. Select an axis (i.e., X, Z).
2. Press Misc ( F9 ) to display the pop-up menu.
3. Highlight BackUp Amp Settings and press
ENTER
. A message is
displayed indicating the amplifier backup file is created.
This reads all parameters from the amplifier and creates a backup file
named DIGAMP-*.BK, where ‘*’ is the selected axis name (i.e., X, Z).
This file is stored on the hard disk drive.
NOTE: The backup file is compatible with the file generated by
MotionMaestro. When functions pertaining to ANILAM AC Drive
are selected, the user needs to have a RS-232 communication
cable connected between the amplifier and the CNC.