Anilam 4200T, Руководство пользователя

Страница: 33 / 48

CNC Motion Setup/Testing Utility
P/N 70000634C
All rights reserved. Subject to change without notice.
November 2009
29
4. Line 4 indicates:
•
The status of the ten inputs of each node.
•
The status of the six outputs of each node.
•
The three-digit decimal value of the digital/analog converter output
for nodes configured as digital/analog.
5. Subsequent lines indicate the I/O status of any additional nodes.
Save Amp Settings
This feature is only for systems equipped with an ANILAM AC Amplifier
(P/N 33001279) and with the Servo Amplifier Communications Cable, P/N
33001389, connected. Refer to “Setting the Signal Gain (F7).”
Saves all modified amplifier parameters to non-volatile memory. This
must be done after performing a signal gain test and/or a balance test.
Balance Test – When Balance test [ Balance ( F6 )] is selected and if the
Communication link between the CNC and ANILAM AC Drive is
enabled/open, the Parameter IAO (Analog 1 Input Offset) will be
displayed and you will be able to modify it by using the up/down
arrow
keys. Use right/left arrow to change the increment amount (which is set
on Setup Utility). Save the final value by selecting Save Amp Settings
[ MISC ( F9 )].
Signal Gain Test – When Signal Gain test [ SigGain ( F7 )] is selected and
if the Communication link between the CNC and ANILAM AC Drive is
enabled/open, the Parameter IAS (100% PWM RPM Value) will be
displayed and you will be able to modify it using the up/down
arrow keys.
Also, the Compensation (equivalent to Comp Pot) parameter GVC
(Velocity Loop Master Gain) will also be displayed; you will be able to
modify it by using right/left
arrow keys. Every time you press the arrow
keys, the value will be incremented by the amount entered in the Setup
Utility. Save the final value(s) by selecting
Save Amp Settings [ MISC
( F9 )].
These two tests should cover the equivalent of Signal, Balance & Comp
Pots on the analog drives.