Anilam 4200T, Руководство пользователя

Страница: 15 / 48

CNC Motion Setup/Testing Utility
P/N 70000634C
NOTE: On 4200T systems, the DSP
2
Board is located in the CNC
chassis. Open the CNC chassis by loosening the thumbscrews
and opening the cover. Balance the DSP
2
Board with the servos
off, initially. Next, verify the DSP
2
Board balance with the servos
on, and correct for voltage offset as required.
1. Press Balance ( F6 ) to output a zero-voltage signal to the axis.
2. Press
START
.
3. Refer to Figure 7 . Make adjustments for axis outputs 0-3 on the
DSP
2
Board at potentiometers R108-R111 respectively.
4. Adjust the potentiometer for the selected axis until the voltage across
the pins is 0VDC (
±
0.001V).
5. Press Manual (F4) to cancel the test.
Table 4, Axis Output Port Assignments
Port Axis
0 X
1 C/S
2 Z
33000404
Output Balance Pot
Port 0
Port 1
Port 2
Port 3
Figure 7, ANILAM DSP
2
Board Balance Pots, P/N 33000404, DC Systems
All rights reserved. Subject to change without notice.
November 2009
11