Anetic Aid QA3 21110, Инструкция по эксплуатации

Страница: 21 / 40

DRIVE Assist Function
Document No. 992012. Issue 19 – 24.10.22 Page 17
20. Introduction to DRIVE Assist
This section of the document explains what
DRIVE
assist means, and how to use it.
The stretcher incorporates a motorised 5
th
wheel, the ‘
DRIVE
wheel’. The assistance the
DRIVE
wheel provides is to help reduce the pushing and pulling forces required to start
and stop the stretcher, and the force required in motion; it is therefore referred to as
‘
DRIVE
assist’.
The pushing handles are attached to sensors that detect the push/pull action on them,
and are termed ‘
DRIVE
handles’.
DRIVE
assist is automatically activated by placing both
hands on the
DRIVE
handles, and pushing or pulling the handles forwards or backwards
to apply a modest amount of start-up motion to the stretcher; see Section 22, ‘Using
DRIVE
Assist’ for a more detailed explanation.
On page 35, the ‘Quick Start Guide for Using DRIVE Assist’, is intended to help you use
DRIVE
assist in a few simple steps. However, it is advisable that these instructions are
read in their entirety before using the equipment.
WARNING: Do not use a stretcher bed push, or other mechanical means for
propulsion of the stretcher, on a stretcher fitted with
DRIVE
assist.
The
DRIVE
feature is available on the following stretchers;
DRIVE
Patient Stretcher
(21112),
DRIVE
Emergency Stretcher (21122),
DRIVE
Powered Patient Stretcher (21114)
and
DRIVE
Powered Emergency Stretcher (21124).
Key to Fig. 13 – User Interface (head end), used on the following products;
DRIVE
Patient Stretcher (21112),
DRIVE
Emergency Stretcher (21122)
1. ON/OFF Button
2. System Status Indicator
3. Read Instructions Indicator
4. Battery Charge Level Indicator
5. Service Indicators
Key to Fig. 14 – User Interface (head end), used on the following products;
Powered Patient Stretcher (21116), Powered Emergency Stretcher (21126),
DRIVE
Powered Patient Stretcher (21114),
DRIVE
Powered Emergency Stretcher (21124)
6. CPR Position Button (see Section 34, ‘Using the CPR Button’)
21. Switching On DRIVE Assist
The stretcher is switched on by depressing the ON/OFF Button (item 1, Fig. 13); at start
up a short beep sounds.
NOTE:
Before switching on
DRIVE
, ensure the
DRIVE
handles are free from external
forces, and nothing is hanging from, wrapped around, or clamped on to, the
DRIVE
handles, as this will prevent successful calibration.