Anetic Aid QA3 21110, Инструкция по эксплуатации

Страница: 7 / 40

Introduction
Document No. 992012. Issue 19 – 24.10.22 Page 3

When folding the transfusion pole away ensure that it is fully retracted and returned
to its storage position within the side rail; failure to do this may cause the pole to get
caught on obstructions when pushing the stretcher.

Using the transfusion pole to either push or pull the stretcher may cause permanent
damage to the transfusion pole and the side rail.

Do not raise the backrest with the x-ray tray, x-ray cassette or digital plate across the
backrest hinge as damage may occur.

Do not use a stretcher bed push, or other mechanical means for propulsion of the
stretcher, on a stretcher fitted with
DRIVE
assist.

The maximum slope angle for
DRIVE
assist is 6°; exceeding this angle could result in
damage to the stretcher or the fabric of the building.

Ensure the mains charging lead is disconnected before attempting to move the
stretcher; failure to do so could result in damage to the stretcher or the fabric of the
building.

Do not stow the fold-away handles when driving, or whilst
DRIVE
assist is active.
Ensure the brakes are engaged before stowing the fold-away handles.

When leaving a patient unattended, always switch off the
DRIVE
assist function and
apply the brakes.

Do not release the stretcher down a slope and rely on the
DRIVE
wheel brake to
control the stretcher descent.

Ensure there is nothing to impede the raising or lowering of the patient platform,
backrest, or KneeFlex as this could result in damage to the equipment and/or injury
to the patient.

Incompatible mattresses can create hazards; only replace the mattress with a new
mattress supplied by Anetic Aid, or your authorised dealer, to ensure compatibility in
accordance with BS EN 60601-2-52:2010+A1:2015.

Disinfectant products are corrosive in nature; failure to properly wash and dry the
stretcher surfaces could leave a corrosive residue which may cause damage to the
stretcher.

Do not use concentrated bleaching disinfectant solutions, organic solvents, abrasive
powders or expose any part of the stretcher to excessive heat.