AMX Optima SD, Инструкция по эксплуатации

Страница: 43 / 82

Hi-Z Sync Input/Output Boards
38 Optima SD Instruction Manual
Attaching Cables
When attaching video input and output cables, refer to the sheet labeled “AutoPatch Optima Connector
Guide” that shipped with the system. The sheet shows where to attach each cable on the rear of each
enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multi-enclosure systems, each enclosure will be numbered (e.g., “Chassis 1
of 2”) on a label located on the left side (near the power receptacle).
The input connectors (white BNCs) are on the left side of each board, and the output connectors (black
BNCs) are on the right side. Input and output connectors are numbered separately. The number of BNC
connectors depends on the I/O configuration. The enclosure may also contain a stereo audio I/O board
depending on the model.
To connect Hi-Z sync inputs and outputs:
1.
Fasten the cables onto the input and output BNC connectors (FIG. 22).
Make sure the video cable is connected to the correct BNC connector on the correct enclosure.
Hi-Z sync boards look similar to 500 MHz video boards, but the “AutoPatch Optima Connector Guide”
identifies them.
Note: For instructions on replacing boards, see “Appendix C – Replacing I/O Boards” on page 67.
FIG. 22
Fasten cables onto input and output BNC connectors