AMX Optima SD, Инструкция по эксплуатации

Страница: 45 / 82

Stereo Audio Input/Output Boards
40 Optima SD Instruction Manual
Stereo Audio Input/Output Boards Specifications
Applies to stereo audio boards contained in the Optima SD systems listed on the previous page.
* Total of input gain plus output gain cannot 10 dB.
AMX reserves the right to modify its products and their specifications without notice.
Attaching Wires
When attaching stereo audio input and output wires, refer to the sheet labeled “AutoPatch Optima
Connector Guide” that shipped with the system. The sheet shows where to attach the wires on the rear of
each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multi-enclosure systems, each enclosure will be numbered (e.g., “Chassis 1
of 2”) on a label located on the left side (near the power receptacle).
The input connectors are on the left side of each stereo audio board, and the output connectors are on the
right side. Input and output connectors are numbered separately. The number of stereo pair connectors
depends on the configuration.
Specifications
Parameter Conditions Value
Frequency Response 20 Hz to 20 kHz <±0.2 dB
THD + Noise f = 20 Hz to 20 kHz, Vin = -10 to +10 dBu
f = 20 Hz to 20 kHz, Vin = 0 to +22 dBu <0.03%
<0.01%
Crosstalk f = 1 kHz, Vin = +20 dBu <-110 dB
Channel Separation f = 1 kHz, Vin = +20 dBu >100 dB
Signal to Noise Ratio (SNR) 20 Hz to 20 kHz, Vin = +20 dBu >120 dB
CMRR 20 Hz to 20 kHz >80 dB
Input Level (max.) Balanced +22 dBu
Input Impedance 18 kohms
Input Gain
Adjustment Range Control panel or serial control ±10 dB
Output Level (max.) Balanced +22 dBu
Output Impedance 50 ohms
Output Volume Control
Adjustment Range* Control panel or serial control +10 dB to -70 dB (mute)
Connector Type Pluggable 5-position terminal block