AMX NetLinx Master-Ethernet Card/Module NXC-ME260, Руководство по программированию

Страница: 116 / 162

Terminal (Program Port/Telnet) Commands
108 NI Series WebConsole & Programming Guide
Terminal Commands (Cont.)
Command Description
SET THRESHOLD
Sets the Master's internal message thresholds.
This command will set the thresholds of when particular tasks are
pended. The threshold is the number of messages queued before a
task is pended.
Use extreme caution when adjusting these values.
Note :
The Master must be rebooted to enable new settings.
Example:
>SET THRESHOLD
-- This will set the thresholds of when particular tasks are
pended. The threshold is the number of messages queued before a task
is pended.--
--Use extreme caution when adjusting these values.--
Current Interpreter Threshold = 2000
Enter new Interpreter Threshold (Between 1 and 2000)(Default=10):
Once you enter a value and press the ENTER key, you get the follow-
ing message:
Current Lontalk Threshold = 50
Enter new Lontalk Threshold (Between 1 and 2000) (Default=50):50
Current IP Threshold = 600
Enter new IP Threshold (Between 1 and 2000) (Default=200): 600
Setting Thresholds to: Interpreter 2000
Lontalk 50
IP 600
New thresholds set, reboot the Master for the changes to
take affect.
SET TIME
Sets the current time.
When the time is set on the Master, the new time will be reflected on
all devices in the system that have clocks (i.e. touch panels). By the
same token, if you set the time on any system device, the new time
will be reflected on the system’s Master, and on all connected devices.
Note : This will not update clocks on devices connected to another
Master (in Master-to-Master systems).
Example:
>SET TIME
Enter Date: (hh:mm:ss) ->
SET TIMELINE LOOPCNT
Sets the Master's timeline/event max loopcount.
SET UDP BC RATE
Sets the UDP broadcast rate. A broadcast message is sent by the
Master to allow devices to discover the Master. This command allows
the broadcast frequency to be changed or eliminate the broadcast
message.
Example:
>SET UPD BC RATE
Current broadcast message rate is 5 seconds between messages.
Enter broadcast message rate in seconds between messages
(off=0 ; default=5) (valid values 0-300):
Once you enter a value and press the ENTER key, you get the follow-
ing message:
Setting broadcast message rate to 300 seconds between
messages
New broadcast message rate set.