Audio/Video Configuration
61
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Video Settings
The Video Out tab enables you to set the resolution, aspect ratio, and picture qualities of each individual video input. Any changes
you make reflect instantaneously on your source input and output devices.
Video Out
FIG. 66 displays the Video Out page for the DVX.
FIG. 66
WebConsole Configuration Page - Video Out Tab
1 -
Output Select
: Select the corresponding option button to select the video output to adjust. When you select an output, the
other options on the page change to reflect the output’s current settings. You can copy the settings from one output to the
selected output by using the Copy From menu.
NOTE:
If you have a Virtual device using the same port (5002) as the DVX, all notifications are routed to virtual device
rather than the DVX. In this case, initial states for the video outputs will not be represented in the Web Console. When
possible, avoid using virtual devices on the same port as the DVX.
2 -
Blank Color/Logo
: Use the drop-down menu to select the color of the blank screen on the output. If you have uploaded a
logo to display on the output, you can also select the logo from this menu.
3 -
OSD
: This area allows you to activate the on-screen display. When enabled, the input name and resolution displays in a small
box in a corner of the screen whenever you select a new input source. From the available menus in the same area, you can
select the color scheme and location of the OSD.
4 -
Select Input
: Use the menu to select a video input to be switched to the selected video output.
5 -
Logo/Test Pattern
: Use the menu to choose an image logo or output test pattern to display on the video output. Select Off
to disable the logo or test pattern and view video from the selected source. You can choose from Off, Color Bar, Gray Ramp,
SMPTE Bar, HiLoTrak, Pluge, and Cross Hatch. If you have uploaded a logo to display on the output, you can also select the logo
from this menu.
6 -
Video Mute
: Click to toggle whether the video is muted (blanked) on the video output.
Freeze
: Click the check box to freeze the current image so that it remains on the screen.
7 -
Logo Setup
: The Logo Setup area enables you to load up to three bitmap image files available for display on the video
output. Click each Upload File button to locate and upload an image file to the unit’s local memory, then click the Flash Logos
button to load the image files into memory. Images must be 24-bit color bitmap files at least 36x36 pixels in size. There is
8192kb of flash memory available for storing the three image files. The amount of free space remaining appears on the screen.
See the
section on page 62 for more information.
NOTE:
Large images can cause a slowdown in performance. Though images up to 1920x1200 are supported, AMX
recommends using an image size no greater than 640x480.
4
1
2
3
7
5
4
6
8
9
11
10