Amsco RELIANCE 444 HTM, Руководство по установке

Страница: 32 / 36

5-4
P-920012-041 Uncrating/Installation Instructions Operational Test
STATUS
STATUS
STATUS
STATUS
INTR. UTENSILS
GLASSWARE PLASTIC
28. From unload side, repeat steps 26 to 27.
29. On load side, press DOOR OPEN touch pad. Display shows:
ACCESS CODE KNOWN?
NO
30. Use VALUE (up or down) touch pad to select: YES.
31. Press CHANGE VALUES touch pad. Display shows:
ENTER OPERATOR
ACCESS CODE: 0000
32. Press CHANGE VALUES touch pad.
33. Place bushings on top of rotary spray hub and reattach rotary
spray arm assembly to top of wash chamber.
34. Replace bottom rotary spray arm assembly and manifold
connector. Replace three set screws previously removed.
35. Remove and clean debris screens under running water. Replace
screens in chamber sump.
36. Insert empty manifold or accessory headers into wash chamber.
37. Close chamber door and press CYCLE/START touch pad to
resume cycle operation.
38. Inspect piping, in upper and lower service compartments, for
leaks. If any leaks occur, tighten appropriate hose clamp
connections and unions.
39. Allow cycle to run to completion. Use the Operator Manual
(P-920012-042) to verify proper unit and cycle operation.
40. On unload side, check that alarm buzzer sounds and that the
following operator instruction appears on display screen once
cycle is complete:
PLEASE OPEN DOOR
AND REMOVE LOAD
41. Open chamber door and allow chamber and accessories to cool
before unloading. Verify display screen returns to the first cycle
menu once door is opened.
42. Remove screens from utility supply-line strainers and check for
debris. Clean screens if necessary.
43. Reinstall all service panels.