Amsco RELIANCE 444 HTM, Руководство по установке

Страница: 17 / 36

2-5
Uncrating Instructions Uncrating/Installation Instructions P-920012-041
Figure 2-4. Tilt Equipment (only if necessary)
Move Equipment and
Remove Skid
1. With unit still mounted on skid, use a forklift to move unit to
installation site.
If necessary, unit may be tilted extremely carefully on its left side
to accommodate narrow conditions. Tilt equipment onto the side
opposite of the control column. (See Figure 2-4. Also refer to
Figure 2-3 for Center of Gravity.)
NOTE: At least four people are required to tilt unit. Unit is heavy and
center of gravity is very high (see Figure 2-3).
2. Remove four lag bolts securing unit base to skid.
NOTE: The front right-hand side lag bolt is located under the
chemical pumps compartment.
3. Remove and discard skid from under equipment. If necessary,
use a piece of plywood as a small ramp to slide unit from skid to
floor.
4. Position unit in final location. Use tubing as rollers and roll the unit
into position.
NOTE: Floor under unit should be level. If necessary, use adjustable
legs to level unit (see Figure 2-3 for Center of Gravity).
Ref.: 920003571
skid
polystyrene
dolly
WARNING - PERSONAL INJURY
AND/OR EQUIPMENT DAMAGE
HAZARD: When moving the unit,
use a forklift. Do not use door(s) or
door handle(s) for lifting.
WARNING - LACERATION HAZ-
ARD: When removing bolts, wear
gloves to protect your hands.