56
098-0007 Rev B
When the controller on the Centurion Plus detects an alarm that requires reset from the list of alarms in
Section 11.1, the following steps will be required to clear the alarm.
Screen Display
Operators Action
When an alarm condition occurs during a
disinfection cycle, the following screen will
appear. Press the “EXIT” button at the bottom of
the display to exit back to the home screen.
NOTE:
All outputs will be shut off during an alarm
condition. The disinfection cycle will be
disabled until the alarm condition is
cleared.
On the Home screen, the user will be presented
with a red border as well as a new button that
says “View Active Alarms”. Pressing the button
will present the user with the list of current
alarms.
Pressing the “Alarm Reset” button will clear all
active alarms if the alarm condition is no longer
present.
NOTE:
The alarm will not reset if the alarm
condition is still active (i.e. Tank
Temperature must drop below “Maximum
Temperature” set-point before the Over
temperature alarm will clear).
Upon resetting all active alarms, press the escape
button to return to the home screen. The home
screen will return to normal and the disinfection
cycle can be restarted at this time.
Содержание 000-HS120
